PASSO 1: DESMONTANDO O CARRINHO E RETIRANDO O RECEPTOR. (STEP 1 DISASSEMBLING THE RC TOY CAR AND REMOVING THE RECEIVER CIRCUIT.)
PASSO 1
DESMONTANDO O CARRINHO RC E RETIRANDO O CIRCUITO DO RECEPTOR.
STEP 1
DISASSEMBLING THE RC TOY CAR AND REMOVING THE RECEIVER CIRCUIT.
Carrinho, rádio e embalagem.
(Toy car, radio and packaging.)
Photo 2
Desmontando o carrinho.
(taking apart the toy car)
Photo 3.
Vista geral do receptor e fios que devem ser liberados.
ATENÇÃO! As cores dos fios são exclusivas do fabricante deste
carrinho, podendo variar segundo cada fabricante!
(Traduction of picture Left-to-right.
-Steering engine, green and yellow wire.
- Black and red wires of battery, power the circuit.
-Light wires (optional for LED).
-Engine traction wires, white and gray-blue.
-Green, antenna wire.
Overview of the receiver and wires to be released. ATTENTION! The colors of the yarns are exclusive to the manufacturer of this toy car, and may vary by manufacturer!)
(Traduction of picture Left-to-right.
-Steering engine, green and yellow wire.
- Black and red wires of battery, power the circuit.
-Light wires (optional for LED).
-Engine traction wires, white and gray-blue.
-Green, antenna wire.
Overview of the receiver and wires to be released. ATTENTION! The colors of the yarns are exclusive to the manufacturer of this toy car, and may vary by manufacturer!)
Photo 4
Desfazendo a solda dos fios do receptor.
(Undo the soldering of the receiver wires.)
Photo 5
Receptor fora do carrinho.
(Receiver outside the toy car.)
Photo 6
Aumentando os fios. Notar a antena alongada em 55 cm para maior alcance (fio roxo).
O alcance do carrinho é de aproximadamente 8 m, insuficiente para o aeromodelo. Acompanhando artigos sobre o tema, constatei que o aumento da antena melhora o alcance em torno de 20-25 metros, no aeromodelo.
(Traduction picture left-to-right:
-Increased antenna wire.
-Black (-) and red (+) wires connected to the battery and energize the entire circuit.
-Wire increased with welding (must be insulated with tape).
-Yarns energizing the tail servo.
-Wires that power the reduction motor and the propeller.
Raising the wires. Note the elongated antenna at 55 cm for longer range (purple wire).
The reach of the toy car is approximately 8 m, insufficient for the model airplane. Accompanying articles on the subject, I noticed that the increase of the antenna improves the reach around 20-25 meters, in the model airplane.)
(PRÓXIMO PASSO: DESMONTANDO O HELICÓPTERO E RETIRANDO A REDUÇÃO.
NEXT STEP: TAKING APART THE HELICOPTER AND REMOVING THE REDUCTION.)
Comments
Post a Comment